Converts arc features into lines replacing the feature geometry with a series of edges interpolated along the arc boundary. Ellipse features are converted into polygons by interpolating edges along the elliptical boundary.
If the input geometry is a path consisting of arcs and lines, or an area whose boundary is such a path, then any arcs in the path will be stroked, also using the Number of Interpolated Edges given.
输入端口
输入
This transformer accepts features with arc or ellipse geometry. Other features are unchanged.
Output Ports
Stroked
All features are output through this port.
Parameters
Stroke By
You can convert arc or ellipse features into lines either by specifying the Number of Interpolated Edges or the Maximum Deviation.
The Number of Interpolated Edges and the Maximum Deviation may either be entered as a number, or can be taken from the value of a feature attribute by selecting the attribute name from the pull-down list.
Number of Interpolated Edges
If this parameter is specified and set to 0, then a reasonable number of edges will be interpolated for the arc.
Maximum Deviation
If the Maximum Deviation is specified and has a value greater than 0, then arcs are converted into lines such that the maximum distance between the lines and the arcs is not greater than the value specified. If the Maximum Deviation value is greater than the primary or secondary axis of the arc or ellipse, then the converted lines will have minimum number of edges possible. If the Maximum Deviation value is smaller than or equal to 0, then the value of the Stroke Maximum Deviation advanced setting set in the workspace is used. If both values are smaller than or equal to 0, then arcs are converted into lines using the Number of Interpolated Edges value of 0.
Make Polygon Out of 360 Degree Arcs
如果此参数设置为是，则具有360度扫描角度的弧功能将被转换为多边形。否则，它们被转换为行。
Example
Editing Transformer Parameters
Using a set of menu options, transformer parameters can be assigned by referencing other elements in the workspace. More advanced functions, such as an advanced editor and an arithmetic editor, are also available in some transformers. To access a menu of these options, click
beside the applicable parameter. For more information, seeTransformer Parameter Menu Options.
Transformer Categories
搜索FME知识中心
搜索有关此变压器的样本和信息FME Knowledge Center.