定向器
波尔的调整方向ygonal feature, a surface or the direction of a linear feature.
Input Ports
When theOrientation TypeisReverse, then points, lines, areas, surfaces and solids are accepted.
When theOrientation TypeisRight hand ruleorLeft hand rule, only areas are accepted.
Output Ports
Features with orientation as specified byOrientation Type.
When theOrientation TypeisReverse, features that are not points, lines, areas, surfaces or solids will be rejected.
When theOrientation TypeisRight hand ruleorLeft hand rule, features that are not areas will be rejected.
Parameters
If the feature is an area, aRight hand ruleorientation causes the outer boundary to have its vertices arranged in a clockwise direction, and the holes to have their vertices in a counterclockwise direction.
The opposite is true whenLeft hand ruleis specified.When theLeft hand ruleis specified, the feature's outer boundary vertices are in a counterclockwise order and the holes have a clockwise ordering.
WhenReverseis specified, the feature's coordinates are flipped so that the first coordinate becomes the last one, and vice-versa.This option is intended for use with features that are not polygonal.This transformer has no effect on solid geometries.Only theReverseoption is available for surface geometries.
IfFlip Appearancesis set toYes, the appearances of each face of a solid input feature will change sides.
Example
Editing Transformer Parameters
Using a set of menu options, transformer parameters can be assigned by referencing other elements in the workspace.More advanced functions, such as an advanced editor and an arithmetic editor, are also available in some transformers.To access a menu of these options, clickbeside the applicable parameter.For more information, seeTransformer Parameter Menu Options.
Transformer Categories
Search FME Knowledge Center
Search for samples and information about this transformer on theFME Knowledge Center.