span8
span4
span8
span4
大家好!
I'm new to FME,so I apologize if I ask for a commonplace.My task is to create a 3D PDF,which will be a sequence of geological layers.Each layer is described by two files in the geotiff format - one corresponds to the top of the geological layer,the second to the sole.
I converted them to TIN-surfaces,afer which I tried to convert them to mesh,but the Mesh-builder transformer rejects them.I also tried to go the way of creating 3D polygons as in this example,but,again,I could not convert polygons to mesh.
Output example and 2 layers are attached.
Thanks!
Use the SurfaceModeller Transformer and have a look at the TINSurface Output Port.There you'll find your Mesh.FME doesn't distinguish between Mesh and TIN,each TIN is of the geometry type Mesh.
© 2019 亚搏在线Safe Software Inc |法律