span8
span4
span8
span4
I am working on a dwg drawing containing all the traffic lines in a city and markings that are on the roads.There is a layer for each type of line or objects (Stop and yield markings for example).The problem with the DWG is that the lines are just drawn with a polyline and contain a custom linetype that gives it the look of shark's teeth but in fact are not single object.The end result should visually be the same but instead of a polyline all teeth's should be block references.
I use an free autocad pluguin mea+ to replace these lines with block references but this is quite a time consuming job in autocad.
Command: mea+Measure with Points/Blocks/Lines/Selection ?: bBlock to insert to Measure path: blok_5010Scale for Blocks,or Graphic for symbol scaled to drawing <1>: 1Blocks rotation,or Aligned with path or Relative angle to path [angle/A/R]:Layer for Blocks,or Current,or Same as selected path
: BLOK_5010Enter length of segment: 1Standard measure alignment or Center on path length [S/C]? : cSelect object to Measure:
I tried looking for a solution in FME but could not find a similar function to replace polylines into block references.Is there a workaround so i can automate this in FME?
RenameNLCS.txtto NLCS.shx and then it is possible to load in together with the dwg.
Hi@jdh009
The Labeller transformer can be used to calculate the locations along the line to place the blocks:
It will also calculate the rotation angle for the blocks at the placement location.The attached workspace illustrates how you can use it to render the VW-5050_STREEP linetype.
© 2019 亚搏在线Safe Software Inc |Legal