span8
span4
span8
span4
Ideabystalknecht·· debugging
If you start a workspace you get a prompt for parameters You realize that you don't want this anymore.You hit Ok and the worspace starts.But...then you want to turn off the "Run with prompt" but it's greyed out.I think it's better to allow the user to adjust this setting while a workspace is running.I will forget to turn it off and will run into an extra prompt again.Déjà vu
tim_woodcommented·
I'm coming at this from a slightly different direction: I want to prompt for certain Workspaces but not others.I forgot to turn off "Run with prompt" once and it stopped Workspaces I was running via scheduled tasks from continuing.But I want other Workspaces to always prompt the user for a value because I need them to enter a value that can't be obtained from the data.
erik_jancommented·
I usually cancel the run before it starts reading if I do not want to use the "Prompt and Run",but sometimes that escapes my attention.In those cases this would be a nice to have.
daleat亚搏在线safecommented·
Seems like a reasonable idea.I'll find out if it is as easy as it sounds...
Share your great idea,or help out by voting for other people's ideas.
Add Rejected Port and Filter Tab to Writer Feature Type
Full Data Inspector inside of Workbench
Add a Warning message whenever the PointOnAreaOverlayer transformer deaggregates MultiPart polygons
Inspect output port for any given transformer
Parameter Value in Breakpoint Condition Defintion
Run with Breakpoints without a Breakpoint Defined
© 2019 亚搏在线Safe Software Inc |Legal