span8
span4
span8
span4
Workbench:
reader1: ECW --> RasterSelector (3 ALL) --> RasterBandRemover -->
Clipper --> writer:JPG
reader2: SHP -->
After starting it I get this:LOG
It just stops until I manually stop it.I use FME 2017.1.0.0.
The strange thing is that when I make the same workbench on a colleagues computer (FME 2017 1.2.1) It runs with no problems and makes the JPG in 1 min.
Hi Koen,
The only thing I can think off is the custom coordinate system.
Is that installed on both machines in the same way?
Hope this helps.
Erik
© 2019 亚搏在线Safe Software Inc |Legal